Electricity generation with the hybrid power generation system
| Author(s) | : | Srinivas Kunta |
| Institution | : | Faculty in KU College of Engineering & Technology, Dept. of Electrical & Electronics, KU campus,Warangal. |
| Published In | : | Vol. 4, Issue 11 — November 2017 |
| Page No. | : | 1186-1193 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
In this study, the electric energy required for feeding of small power receivers at twolaboratories of KU college of Engineering and Technology, Department of Electrical and Electronics is met byhybrid wind-solar power generation system. For this purpose, 600 W 3-phase permanent magnet synchronousgenerator (PMSG) based wind power generation system (WPGS) and solar power generation system (SPGS)consisting of 190W 3 pieces mono crystal solar panel are combined to build a 1170W wind-solar hybrid powergeneration system. Besides, to accumulate the consumption excess electric energy or lack of generation, toensure energy continuity via renewable power system, 100 Ah 12V 6 pieces gel jeep cycle accumulator groupsare installed on the wind-solar hybrid power generation system (WSPGS). Then, the block diagrams of thesystem elements forming the hybrid power generation system and SimPowerSystems in the Matlab/Simulink areused to realize the simulation of the wind-solar hybrid power generation system with battery support. When thecurves obtained from the simulation results are examined, it is determined that the electrical and mechanicalmagnitudes in parallel to the dynamic behavior of the installed hybrid power generation system are so similar.
Srinivas Kunta, “Electricity generation with the hybrid power generation system”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 4, Issue 11, pp. 1186-1193, November 2017.
