MAPPING OF STRESS DISTRIBUTIONS OF HANGAR ROOF SYSTEMS IN ANSYS SOFTWARE
| Author(s) | : | Selim Taskaya, Semih Taskaya |
| Institution | : | Department Architecture and Urban Planning, Artvin Coruh University, Artvin, Turkey-08100 |
| Published In | : | Vol. 6, Issue 2 — February 2019 |
| Page No. | : | 82-89 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
The hangar roof system is covered with a roof that is carried by overhead steel posts or columns that protectvarious goods or tools from external influences. Ansys software programs is a simulation software program used inengineering areas in recent years. Studies related to this program are used after the design phase and before theprototype is produced, it allows testing in a virtual environment. With the 3-dimensional 54 edge and 35 cornercoordinate points, the hangar roof model formed with 46x50 mm base supporting cylinder pipe diameter was applied 200Newton force to 5 support beam points. The deformation and stress distributions of the roof top beam and supportingnodes were mapped by the applied force. As a result of the analyzes, it was observed that deformation and stresses in theload-bearing upper beam and base coordinate points increased and the pre-supporting beam points decreased.
Selim Taskaya, Semih Taskaya, “MAPPING OF STRESS DISTRIBUTIONS OF HANGAR ROOF SYSTEMS IN ANSYS SOFTWARE”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 6, Issue 2, pp. 82-89, February 2019.
