Optimization of Process parameters in Injection Moulding of Cam Bush using DFA and ANOVA
| Author(s) | : | G. Sambasiva Reddy, B. Prasad Kumar, P Venkataramaiah |
| Institution | : | M.Tech (student), Department of Mechanical Engineering, S.V. University, Tirupati-517502 |
| Published In | : | Vol. 5, Issue 3 — March 2018 |
| Page No. | : | 644-650 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
Injection Moulding is a versatile manufacturing technique for forming of plastics. Present work is focused onoptimizing the process parameters to obtain the better quality for Cam bush. Polymer Matrix Composites were usedtofabricate Cam Bush. Cam bush is used as an indexing device in ON/OFF Load Tap changer device of high voltagetransformer and serves as the connector between the indexing head and the power changing gears. Injection pressure,Injection Speed, Holding pressure is the input parameters which influence the quality characteristics of Cam Bush such asShrinkage,Warpage and Surface Roughness.Cam bushes are produced according to Taguchi’s experimental design(L27) andthe response values are recorded.Thisdata are analysed and optimized by DFA.
G. Sambasiva Reddy, B. Prasad Kumar, P Venkataramaiah, “Optimization of Process parameters in Injection Moulding of Cam Bush using DFA and ANOVA”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 5, Issue 3, pp. 644-650, March 2018.
