MQL: Sustainable Cooling Process for Taper Turning of En31 Steel
| Author(s) | : | Prof. Anup Junankar, Shubham Mehar, Nityanand Chauhan |
| Institution | : | Asst. Professor, Department Of Mechanical Engineering, J D College of Engineering & Management, Nagpur-441501, Maharashtra. |
| Published In | : | Vol. 5, Issue 2 — February 2018 |
| Page No. | : | 137-139 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
Due to climate change today, “going green” is essential for manufacturing industries. Industrial cuttingfluid affects the environmental pollution and also to the employee health. This research paper concerning on reducinguse of cutting fluid by implementing Minimum Quantity Lubrication (MQL). MQL system uses only 5ml to 50ml/hr oflubricant in machining, where in flood this quantity is very much high. This paper also concentrate on better surfacefinish and reducing cutting fluid cost and investigation of tapper turning operation on EN- 31 material, for optimizationof surface roughness, material removal rate in dry, flood and MQL system by considering three controllable inputparameters that are cutting speed, feed rate, depth of cut.
Prof. Anup Junankar, Shubham Mehar, Nityanand Chauhan, “MQL: Sustainable Cooling Process for Taper Turning of En31 Steel”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 5, Issue 2, pp. 137-139, February 2018.
