AN INVESTIGATION OF TEMPERATURE, SURFACE ROUGHNESS AND MATERIAL REMOVAL RATE OF EN19 MATERIAL USING TUNGSTEN CARBIDE TOOL DURING HARD TURNING ON LATHE MACHINE
| Author(s) | : | Mr. Amol N. Varade, Mr. Kamlesh P. Kadia |
| Institution | : | Department of Mechanical Engineering (CAD/CAM), LJIET, Ahmedabad |
| Published In | : | Vol. 2, Issue 5 — May 2015 |
| Page No. | : | 74-82 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
The main aim of this Project work is to study experimentally the influence of depth of cut, cutting speed, andfeed rate on the tool tip temperature, Material Removal Rate, Surface Roughness during turning process. Theexperiments will be obtained by varying one parameter while, the remaining two parameter were kept constant. So theinfluence of tool tip on different machining parameters is done in this research work. To increase the tool life, TaguchiOptimization method is used to optimization of machining parameters. Through this study, not only the optimal cuttingparameters for turning operations are obtained, but also the main cutting parameters that affect the cutting performancein turning operations will be evaluated. Experimental results will be provided to confirm the effectiveness of thisapproach. It will give the best result for turning operation of EN19 Material.
Mr. Amol N. Varade, Mr. Kamlesh P. Kadia, “AN INVESTIGATION OF TEMPERATURE, SURFACE ROUGHNESS AND MATERIAL REMOVAL RATE OF EN19 MATERIAL USING TUNGSTEN CARBIDE TOOL DURING HARD TURNING ON LATHE MACHINE”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 2, Issue 5, pp. 74-82, May 2015.
