Evaluation of Process parameter ranks in WIRE-Electric Discharge Machining of INCONEL X750 using Brass Electrode
| Author(s) | : | Er. Navneet Singh Virk, Er. Mandeep Chahal |
| Institution | : | Research Scholar , Department Of Mechanical in Haryana college of technology and management, Kaithal |
| Published In | : | Vol. 2, Issue 6 — June 2015 |
| Page No. | : | 35-43 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
Much of modern day machining is carried out by WEDM .In this research work an attempt has been made toanalysis the effects of input parameters such as Pulse On time, Pulse Off time and Peak current, on output parameter such asmaterial removal rate and surface roughness. The experiment was performed with different combination values of inputparameter. An attempt has been made to optimize the machining conditions for MRR and surface roughness based on (L9Orthogonal Array) Taguchi methodology. Experiments were carried out under varying pulse-on-time, pulse-off-time, andpeak current. An orthogonal array, the signal-to-noise (S/N) ratio, and the analysis of variance (ANOVA) were employed tothe study the MRR and surface roughness in the WEDM of INCONEL X750.
Er. Navneet Singh Virk, Er. Mandeep Chahal, “Evaluation of Process parameter ranks in WIRE-Electric Discharge Machining of INCONEL X750 using Brass Electrode”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 2, Issue 6, pp. 35-43, June 2015.
