EXPERIMENTAL INVESTIGATION OF EFFECTS OF CUTTING PARAMETER BY DIFFERENT CUTTING PATHS OF FACE MILLING OF WORK PIECE
| Author(s) | : | Nitin B. Katrodiya, Prof. Harshad D. Patel |
| Institution | : | Mechanical Engg. Department, Government Engg. College, Dahod, katrodiyanitin@gmail.com |
| Published In | : | Vol. 1, Issue 5 — May 2014 |
| Page No. | : | 238-241 |
| Domain | : | Engineering |
| Type | : | Research Paper |
| ISSN (Online) | : | 2348-4470 |
| ISSN (Print) | : | 2348-6406 |
In end milling which is often encountered in die manufacture, the demand is to narrowthe interval between the surface roughness values obtained at finish milling and the surfaceroughness values will be met by further finishing operations as far as possible. The implementationand selection of cutting path strategies with appropriate cutting parameters have significant effect onsurface roughness. The effect of every single variable on surface roughness is known, however, whatkind of results is revealed in their combinations cannot be clearly estimated. The aim of this study is,first, to investigate optimum cutting characteristics of OHNS steel on cutting path strategies usinghigh-speed steel end mills. The cutting parameters considered are spindle speed, feed rate, and depthof cut. The second aim is to identify the effects of cutter path strategies when employing in facemilling. The both aims will be addressed by means of using Taguchi parameter design.
Nitin B. Katrodiya, Prof. Harshad D. Patel, “EXPERIMENTAL INVESTIGATION OF EFFECTS OF CUTTING PARAMETER BY DIFFERENT CUTTING PATHS OF FACE MILLING OF WORK PIECE”, International Journal of Advance Engineering and Research Development (IJAERD), Vol. 1, Issue 5, pp. 238-241, May 2014.
