Analysis of Specific cutting energy in High Speed Turning of Inconel 718 by using Ceramic Tools

Authors

  • Ganesh S. Sonawane PG Student, Mechanical Engineering Department, S.S.G.M.C.O.E, Shegaon, M.S. India
  • Chinmay V.Patil Assistant Professor, Mechanical Engineering Department, S.S.G.M.C.O.E, Shegaon, M.S. India
  • Raju S. Pawade ssociate professor, Dept. of Mechanical Engineering, Dr. Babasasheb Ambedkar Technological University, Lonere, M.S.

Keywords:

: High speed machining, Advance ceramic tools, Specific cutting energy, Inconel 718.

Abstract

he paper presents an experimental investigation of specific cutting energy of super alloy Inconel 718 during
high speed turning using advanced ceramic grade KYS25 and KYS30 inserts with two different nose radii. The effect of
machining parameters on cutting ratio was investigated in dry machining. As cutting speed increases specific cutting energy
decreases hence less forces are required to shear work piece material in shear zone.

Downloads

Published

2015-01-25

Issue

Vol. 2 No. 1 (2015): Volume 2 Issue 1, January 2015

Section

Articles

How to Cite

Analysis of Specific cutting energy in High Speed Turning of Inconel 718 by using Ceramic Tools. (2015). International Journal of Advance Engineering and Research Development (IJAERD), 2(1), 334-341. https://www.ijaerd.org/index.php/IJAERD/article/view/474

Similar Articles

1-10 of 2369

You may also start an advanced similarity search for this article.