DESIGN OF FIXTURE AND ANALYSIS OF RUNNER SYSTEM IN PLASTIC INJECTION MOLDING

Authors

  • B.Dhanasakkaravarthi Assocoate Professor Department of Mechanical engineering, Panimalar Institute Of Technology, Tamilnadu ,India. Chennai-123
  • N.Nithyanandan Professor Department of Mechanical engineering, Panimalar Institute Of Technology, Tamilnadu, India. Chennai-123
  • K.Balasubramanian Assocoate Professor Department of Mechanical engineering, Panimalar Institute Of Technology, Tamilnadu ,India. Chennai-123
  • S. Santhosh Kumar Assistant Professor Department of Mechanical engineering, Panimalar Institute Of Technology, Tamilnadu, India. Chennai

Keywords:

Reduction of wastages, plastic injection molding, runner systems, thermal analysis

Abstract

The main aim of our project is to reduce the time consumption and wastage of plastics in plastic injection
molding of JACK END CAP. For this we have designed a fixture which is used fix the terminal into the product. This will
reduce the production time and also it will help the worker to do the work with safety. In plastic injection molding
currently partial hot runner system is being used which will reduce the wastage of material. For normal plastic injection
molding most of the industries are using cold runner system. The main drawback in cold runner system is high wastage.
By using partial hot runner high wastage will be reduced. Because, in partial hot runner the runner path way will be
kept in molten state. So the wastage will be reduced and also it will increase the production rate.

Downloads

Published

2018-04-25

How to Cite

B.Dhanasakkaravarthi, N.Nithyanandan, K.Balasubramanian, & S. Santhosh Kumar. (2018). DESIGN OF FIXTURE AND ANALYSIS OF RUNNER SYSTEM IN PLASTIC INJECTION MOLDING. International Journal of Advance Engineering and Research Development (IJAERD), 5(4), 1884–1890. Retrieved from https://www.ijaerd.org/index.php/IJAERD/article/view/3305

Issue

Vol. 5 No. 4 (2018): Volume 5 Issue 4 April 2018

Section

Articles