DESIGN AND DEVELOPMENT OF SPECIAL PURPOSE MACHINE FOR AUTOMATIC ASSEMBLY OF NUT AND SHACKLE ON BRAKE BOOSTER

Authors

  • V. R. Kale Department of Mechanical Engineering, S.S.G.M.C.E. Shegaon
  • Dr. S. P. Trikal Department of Mechanical Engineering, S.S.G.M.C.E. Shegaon

Keywords:

Break booster, CAD, design, development, LVDT, Servo motor, Global automation

Abstract

In this project, the task is to design a machine for assembly of nut and shackle on stud of a brake booster and
set the height of shackle pin on stud as per the requirements for each booster. Now this operation is done by manually.
Generally two to three operators are required to perform this task, and take 1 to 1:30 min. to finish the job. This employs
the manpower which introduces manual errors in the production. Thereby, giving rise to unnecessary errors and reduced
productivity. This operation can be achieved by designing and developing a SPM for automatic assembly of nut and
shackle pin on a break booster. This project is sponsored by Global Automation, talwade road, ganrsh nagar, pune.

Downloads

Published

2015-12-25

How to Cite

V. R. Kale, & Dr. S. P. Trikal. (2015). DESIGN AND DEVELOPMENT OF SPECIAL PURPOSE MACHINE FOR AUTOMATIC ASSEMBLY OF NUT AND SHACKLE ON BRAKE BOOSTER. International Journal of Advance Engineering and Research Development (IJAERD), 2(12), 131–139. Retrieved from https://www.ijaerd.org/index.php/IJAERD/article/view/5276

Issue

Vol. 2 No. 12 (2015): Volume 2 Issue 12, December 2015

Section

Articles