ECONOMIC COMPARISON OF ADDITIVE AND CASTING METHOD OF MANUFACTURING

Authors

  • Rohit mehta PLM - Coordinator at Product Life-cycle Management Department, TATA Technologies Limited,
  • Shubham gupta Mechanical engineer (Hons.), Rajasthan Technical University

Keywords:

Designing; casting; extrapolation; Breakeven; 3-D printing; Manufacturing; Minimum efficient scale

Abstract

This paper compares the cost of additive manufacturing with casting manufacturing method follows a detail
breakdown of cost per piece. Extrapolating the data and plotting a chart to proof the statement of various economic theories
suggested in the direction of AM.

Downloads

Published

2019-01-25

How to Cite

Rohit mehta, & Shubham gupta. (2019). ECONOMIC COMPARISON OF ADDITIVE AND CASTING METHOD OF MANUFACTURING. International Journal of Advance Engineering and Research Development (IJAERD), 6(1), 119–123. Retrieved from https://www.ijaerd.org/index.php/IJAERD/article/view/4039

Issue

Vol. 6 No. 1 (2019): Volume: 06, Issue: 01 - January, 2019

Section

Articles