STUDY THE EFFECT OF CARBIDE AND HSS DRILLING ON SURFACE ROUGHNESS OF Al/SiC-MMC

Authors

  • Parveen Kumar Saini Assistant Professor, Mechanical Engineering Deptt., Chandigarh Engineering College, Landran (Mohali)
  • Gurkirat Singh Assistant Professor, Mechanical Engineering Deptt., Chandigarh Engineering College, Landran (Mohali)

Keywords:

Al/SiC-MMC, Stir Casting, Taguchi Method, ANOVA Method, Drilling of MMC, Surface Finish

Abstract

This paper presents an experimental investigation of the influence of drilling conditions on surface finish of
hole during drilling of Al/SiC-MMC. Taguchi method and Analysis of variance (ANOVA) is employed to investigate the
influence of spindle speed, feed rate and drill bit material (Carbide and HSS) on surface finish of hole. Through various
graphical representations it can be concluded that lower spindle speed and lower feed rate are the suitable parameters for
better surface finish for carbide drill. Higher spindle speed and higher feed rate are suitable parameters for HSS drill.

Downloads

Published

2014-10-25

Issue

Vol. 1 No. 10 (2014): Volume 1 Issue 10 (October-2014)

Section

Articles

How to Cite

STUDY THE EFFECT OF CARBIDE AND HSS DRILLING ON SURFACE ROUGHNESS OF Al/SiC-MMC. (2014). International Journal of Advance Engineering and Research Development (IJAERD), 1(10), 95-99. https://www.ijaerd.org/index.php/IJAERD/article/view/301

Similar Articles

1-10 of 4752

You may also start an advanced similarity search for this article.